Skip to main content

Overrides

Override group allocation for an Experiment​

During development, it can be useful to explicitly state which experiment group a user should fall into. For example, if a developer is testing that each of the experiment conditions work as expected, they may want to force themselves into each of the different conditions to test.

Overrides can be added based on Feature Gates and Segments, and will allow you to create rules that force all users that pass a given Feature Gate or Segment to be allocated to a given group. When fetching parameters for an experiment, if the user matches any of the overrides, the overridden result will be returned immediately.

Note
  • For Experiments that are in a Layer, the overrides are set at the Layer level, and a user can only be overridden in to one Experiment within that Layer.
  • Users in overrides are excluded from Pulse results. Since these users are not randomized, we purposely exclude them from experimental results. Adding a large number of users to the override can affect the reliability of your experimental results.

overrides modal

Adding an Override​

  • Log into the Statsig console at https://console.statsig.com
  • On the left-hand navigation panel, select Experiments
  • Select the experiment where you want to add an Override, and navigate to the Setup tab
  • Click the Manage Override button, configure the override, and hit Save

overrides modal

Deleting an Override​

If you add an override but later decide it is no longer needed. You can remove it so the rules will be evaluated as normal.

  • Log into the Statsig console at https://console.statsig.com
  • On the left-hand navigation panel, select Experiments
  • Select the Experiment or Layer from which you want to delete the Override
  • Click the Manage Overrides button
  • Click on the trash can icon next to the override you would like to delete, and hit Save

Testing an Override​

Once your override has been added, you can test it in the "Check Group for a User" window by navigating to the Diagnostics tab, and then adding the necessary properties that would be required to make a user pass the gate or segment that was added as an override.